|
American Permahedge™ Installation instructions 1. Start at one end, at the top of the fence. 2. Slide one piece of Permahedge down vertically, with pointed end down. 3. Continue sliding down, without weaving, until you have reached the desired height. (Usually just below the top of the fence). 4. Continue to install using the same method, one piece at a time until entire fence is filled in. |
 |
PVT® Plastic Vertical Tubing Installation instructions 1. Slide a Slat down vertically with locking tab on top. 2. Move locking strip horizontally to lock first slat. 3. Continue to install one slat at a time. |
 |
| Weed Barrier: Installation instructions for all grades 1. Roll out weed barrier and cut to desired length. If overlapping fabric, allow 2 – 3" of overlap. 2. For new plants, cut an X in the fabric large enough to plant through. If plant exists, cut an X large enough to slip fabric over the plant or shrub. If very large shrubs or trees are present, then cut a slit from the edge of the fabric to the base of the tree and slip the fabric around the base. Since the slit will tend to expose the soil below and allow weeds through, it is recommended that the slit be overlapped with strips of fabric wide enough to overlap the slit by 2" – 3" on each side. 3. Cover the fabric with a minimum of 3" of bark or mulch. If covering with stone, marble chips or crushed clay then cover with at least 3" – 4" of material, and use enough small sized pieces to fill in the resulting spaces. All landscape fabrics are weakened by U.V rays of the sun which makes complete coverage important for long term satisfying results. |
 |
 |
Patrician Products Inc., © 2006 Patrician Products Inc. All rights reserved. company | our products | where to buy | FAQs | whats new | contact us
100 Frank Road, Hicksville, N.Y. 11801
Phone: 800-843-7528 / 800-THE-SLAT
Fax: (516) 931-0719
e-mail online Sales